How to use the Nox® Mega Bags

• Before opening the Nox® Mega Bag, assemble the Nox® Portal (refer to the Nox® Portal assembly manual).

• Place it on a flat surface by rolling it out. 

• The surface must be sheltered, clean, and free of bumps. Clear and sweep the surface if necessary.

• Extend the rails at the front of the Nox® Portal.

• Unpack the Nox® Mega Bag and unfold it so that it covers the entire interior surface of the Nox® Portal.

• Be sure to place the Nox® Mega Bag in the correct direction: strings facing up and opening facing the front of the Nox® Portal.

• Attach the cords at the 4 bottom corners of the Nox® Mega Bag to the 4 legs of the Nox® Portal.

• Pass the 2 blue side cords through the rings along the entire length of the Mega Bag.

• Attach the white cords at the 4 top corners of the Nox® Mega Bag to the 4 legs of the Nox® Portal.

• Finally, attach the white cords from the entrance sleeve to the extendable rails of the Nox® Portal.

• Lift the Nox® Mega Bag and thread the blue cords through the suspension hooks located along the entire length of the Nox® Portico (this step requires 2 operators).

• Remove the protective elements from the valves on both sides of the Nox® Mega Bag.

• Step inside the Nox® Mega Bag, finish positioning the liner correctly on the floor, and smooth out any creases.

• Protect the ground with the protective covering.

• Ensure that there are no folds or obstacles hindering the passage of the wheels of the loading machine.

• Place the protective corners on the ground at the two corners of the bottom of the Nox® Mega Bag.

• Detach the two white cords from the lower rear corners.

• Place the first two pallets inside the Nox® Mega Bag (this step requires two operators: a driver and a guide).

• Move forward very slowly, taking care not to snag the liner with the wood of the pallet or the loading equipment.

• Place the remaining pallets inside the Nox® Mega Bag.

• Detach the two white cords from the front bottom corners.

Caution, if the pallets loaded into the Nox® Mega Bag exceed the width of the Nox® Portico's feet, you will no longer be able to move it.

• Equip yourself with personal protection equipment: CO₂ alarm, goggles, and gloves.

• Insert the dry ice boxes into the Nox® Mega Bag, as close to the center as possible.

• Cover them to prevent condensation from forming due to localized cold.

• If applicable, place the Nox® Control System sensor in the Nox® Mega Bag, as close to the center as possible.

• Heat seal the Nox® Mega Bag opening using the heat sealer (this step requires 2 operators).

• Detach the 6 upper white cords.

• Remove any remaining air from the Nox® Mega Bag using the suction valves on its surface.

• Remove the Nox® Portal and fold down the extendable rails.

• Regularly analyze the gas concentration inside the Nox® Mega Bag.

• If necessary, add more CO₂ using the injection valves located on its surface.